Skip to content
PRD-03Sheet 03 of 06

Bevel Gear Sets

Bevel gear sets, lapped and supplied as a pair.

Straight and spiral bevel sets for right-angle drives, with the contact pattern checked and the mounting distance marked on every pair.

Overview

A bevel set lives or dies by its contact pattern.

We make straight and spiral bevel gear sets for right-angle gearboxes, differentials and auxiliary drives.

Pinion and gear are cut, hardened and lapped together, then the pattern is checked on a roll tester. Each set ships matched and marked with its mounting distance, so it assembles the way it was tested.

3D render of a steel spiral bevel pinion meshed with its bevel gear at a right angle
Fig. 1Bevel Gear Sets

Specification

Spec sheet

MakerTorvik Engineering Pvt. Ltd.
TitleBevel Gear Sets
Part no.PRD-03
01Module
1 to 8
02Ratio
1:1 to 6:1
03Diameter
Up to 400 mm
04Type
Straight or spiral
05Material
18CrNiMo7-6, 20MnCr5
06Supply
Matched, lapped pairs
UnitsSI
ScaleNTS
Sheet03 of 06
NoteQuoted per part, from first article to volume supply.

Scope of supply

What we make

Matched pairs
Pinion and gear never separated after lapping.
Pattern checked
Contact recorded before dispatch.
Ready to fit
Mounting distance marked, shims supplied on request.
  1. 01Straight bevel gear sets
  2. 02Spiral bevel gear sets
  3. 03Case hardening and lapping
  4. 04Contact-pattern check on a roll tester
  5. 05Mounting distance marked on each pair
  6. 06Shims and spacers to suit

Typical applications

Where these end up.

Right-angle gearboxes

Input stages for helical-bevel and bevel reducers.

Off-highway axles

Final drives and differentials for tractors and site machinery.

Power take-offs

Auxiliary drives turning a corner in a tight envelope.

Quality, every batch

Shipped with the report to prove it.

  1. Dimensional reportMeasured results for every characteristic on the drawing, in-process and final.
  2. Material certificateThe certificate for the material used, traceable to the heat.
  3. First article reportA full first-article inspection report (FAIR) signed off before batch supply.
  • Drawings read to BS, ASME and ISO conventions
  • In-process and final inspection, SPC
  • Documented NCR and CAPA closure on every batch

Need a bevel set made or replaced?

Send us a brief and we will design it. Send us a drawing and we will make it. Either way you get one team and one point of accountability.

Reference PRD-03 in your enquiry

Next partPRD-04Worm DrivesWorm drives for high ratios in a small space.