Skip to content
PRD-05Sheet 05 of 06

Racks & Pinions

Racks and pinions for straight, repeatable travel.

Gear racks and pinions for linear axes, gantries and transfer systems, straight or helical, with ends finished so lengths join without a step in pitch.

Overview

Long travel, held to pitch.

We make gear racks and matching pinions for linear motion: machine-tool axes, gantry robots, transfer lines and sliding doors on heavy equipment.

Racks are milled, hardened and ground on their mounting faces, and the ends are machined so lengths butt together with the pitch carried across the joint. Pinions are cut to the same module and checked against the rack they will run on.

3D render of a steel spur pinion meshed with a straight gear rack
Fig. 1Racks & Pinions

Specification

Spec sheet

MakerTorvik Engineering Pvt. Ltd.
TitleRacks & Pinions
Part no.PRD-05
01Module
1.5 to 8
02Length
Up to 2,000 mm per piece
03Pitch error
±0.02 mm over 300 mm
04Teeth
Straight or helical
05Material
C45, 42CrMo4
06Hardening
Induction, 50–55 HRC
UnitsSI
ScaleNTS
Sheet05 of 06
NoteQuoted per part, from first article to volume supply.

Scope of supply

What we make

Clean joins
Ends machined so pitch carries across lengths.
Matched pinions
Cut and checked to run on the rack supplied.
Helical option
Helical teeth for smoother, quieter travel.
Ready to bolt down
Holes and dowels machined to your drawing.
  1. 01Straight and helical gear racks
  2. 02Matching pinions, bored or on shaft
  3. 03Ground mounting faces and ends
  4. 04Joined lengths with pitch carried across
  5. 05Induction-hardened teeth
  6. 06Mounting holes and dowels to drawing

Typical applications

Where these end up.

Gantries

Long-travel axes on cutting tables, gantry robots and portal machines.

Machine tools

Feed axes beyond the practical length of a ball screw.

Transfer systems

Shuttles and lifts that move parts between stations.

Quality, every batch

Shipped with the report to prove it.

  1. Dimensional reportMeasured results for every characteristic on the drawing, in-process and final.
  2. Material certificateThe certificate for the material used, traceable to the heat.
  3. First article reportA full first-article inspection report (FAIR) signed off before batch supply.
  • Drawings read to BS, ASME and ISO conventions
  • In-process and final inspection, SPC
  • Documented NCR and CAPA closure on every batch

Need a rack and pinion for a linear axis?

Send us a brief and we will design it. Send us a drawing and we will make it. Either way you get one team and one point of accountability.

Reference PRD-05 in your enquiry

Next partPRD-06Shafts & Splined PartsShafts and splined parts, turned, cut and ground.